Weekly pool service and repairs in Menifee and southwest Riverside County

Call or text (951) 587-5021

Pool Leak Detection in Murrieta, CA

A lot of Murrieta pools went in during the 1990s and 2000s, and at 20 to 30 years old they’ve reached the age when leaks start. Mirage Pool Services tracks down pool leaks in Murrieta, from Bear Creek and Greer Ranch to the big lots in Los Alamos Hills, and repairs them at the pad and in the plumbing.

  • Skimmer and light niche checks
  • Valve and fitting repairs
  • Lines pressure tested

I’ve been a customer for over 3 years and I’ve never had any problems. Reliable and fair.

Brooklyn Marquez, Google review
Clear pool water along the steps and coping

Get a free quote in Murrieta

Tell us what you need and we’ll call you back.

Free, no obligation. We only use your number to call you back.

Where older Murrieta pools start leaking

Pools from Murrieta’s boom years were built well, but certain parts wear out right on schedule. These are the leaks we run into most.

The skimmer pulls away from the wall

The skimmer throat is a separate piece set into the shell. Years of settling can crack that joint or open a gap.

Water follows the light conduit

Once the seal at the light niche ages out, water can find its way down the pipe that carries the light cord.

Return fittings crack

Plastic return fittings in the wall get brittle with age and can crack or work loose.

Valves weep at the pad

Valve O-rings flatten and dry out after decades of heat. A valve that only drips while the pump runs is easy to miss.

The deck has settled

Ground movement around an older deck stresses the pipes underneath and the joints where they meet the pool.

Topping off with the hose every few days?

Backyard pool at dusk

We hear it every summer. Someone has been running a hose into the pool for weeks, figuring it’s just the heat. Murrieta does get hot, but evaporation has a ceiling, and a pool that needs the hose every few days is usually past it.

A quick check before you call: turn off any auto-fill, set a bucket of pool water on the top step, mark the line inside the bucket and the pool’s line on the outside, and look again in 24 hours. If the pool dropped a lot more than the bucket, it’s leaking.

Every week of topping off means fresh water diluting the chlorine, more hard water calcium at the tile line, and more water soaking into the soil under the deck. Older decks don’t need the help.

How we check an older Murrieta pool

We work from the likely spots toward the harder ones, so you’re not paying for a line test when the problem is a valve.

Technician working on a pool heat pump and filter

The pad first

Pads from that era have often been rebuilt in pieces: a newer pump, the original filter, valves nobody has touched in years. We check every valve, union and fitting with the system running and look for damp soil or white mineral trails where a drip has been.

Then the shell

Skimmer throats, light niches, steps and return fittings age worst, so they get a close look. On lots near the oaks, spring leaves and pollen pack the skimmer, so we clear it out completely before judging the throat.

Then the lines

If the pad and shell check out and the pool still drops, we pressure test the lines one at a time. That tells us which line is losing water, so any talk of digging is about one run of pipe, not the whole yard. For a crack in the shell or a line under the deck, we explain what we found and the options.

Pool leak repair in Murrieta and related fixes

We handle pool leak repair in Murrieta at the pad and in the plumbing. Older pools rarely have just one thing wrong, so these pages often come up on the same call.

Pool repair in Murrieta

Timers, valves, lights and pads that have been patched over the years.

Pool pump repair in Murrieta

Leaking shaft seals and pumps that lose prime from a suction side leak.

Pool filter repair in Murrieta

Cracked tanks, worn O-rings and leaking valves on older filters.

The full leak process is on our pool leak detection and plumbing repair page. To have someone watching the water line every week, ask about weekly pool service in Murrieta.

Murrieta pool leak questions

My pool is over 20 years old. Is it more likely to leak?

Age alone doesn’t cause a leak, but the parts most likely to leak are the ones that wear with time: valve O-rings, skimmer joints, light niche seals and plastic fittings. A 1990s or 2000s pool that has never had those checked is worth a look if the level keeps falling.

Can ground settling cause a pool leak?

It can. Soil that moves or settles around an older deck stresses the pipes underneath and joints like the skimmer throat. Cracks in the deck near the pool, or a skimmer that looks out of line, are worth checking.

I’ve been adding water with a hose all summer. Is that normal in Murrieta?

Some topping off in summer is normal, since heat and wind take water. Running the hose every few days is usually more than evaporation, and a bucket test will tell you in about a day.

What does it mean if my pool stops dropping at the bottom of the skimmer?

That usually points to the skimmer or the line running from it, often a throat separating from the shell. Water escapes until the level falls below the opening, then the loss stops. We check the skimmer and pressure test its line.

Can a leaking valve at the equipment pad lose much water?

More than people expect, especially one that only drips while the pump runs. A slow drip over long summer run times adds up. It’s also one of the easier leaks to fix, with new O-rings or a new valve.

Find out where your water is going

Tell us how old the pool is, how often you add water and whether there’s an auto-fill. We’re a short drive down I-215 from Menifee, and Adam can often narrow it down before anyone opens the gate.

Call (951) 587-5021 to get started.

Request a free quote

We use your details only to reply to this request.